Electric steering racks (EPS / EPAS) with ECU diagnostics
Electric power steering racks fail differently from hydraulic ones: a warning light, assistance that cuts out when warm, or a torque sensor fault stored in the ECU. We supply tested EPS and EPAS racks with motor and control unit checked, plus support for coding the unit to your car.
What is checked on every EPS rack
Motor and torque sensor tested
The assist motor and torque sensor are checked under load, since these are the most common EPS failure points.
Control unit diagnostics
The ECU is scanned for stored faults and verified for communication before the rack is released.
Coding and adaptation support
Most EPS racks need coding to the vehicle after installation. We tell you exactly what your workshop needs to do.
Mechanical rebuild included
Bearings, bushings, the rack bar and boots are inspected and replaced when worn — not just the electronics.
Why VIN matters even more with EPS
EPS racks carry software and hardware revisions that are not visible from the outside. A physically identical rack can be incompatible with your car's CAN configuration, so the VIN is essential.
- VIN and exact production date
- Part number and software version from the old rack or ECU label
- Fault codes read from the steering module
- Whether the car has lane keeping, park assist or variable ratio steering
Ordering in four steps
1.Send diagnostics
Provide the VIN, the fault codes and photos of the rack or ECU label.
2.We match the variant
The correct hardware and software revision is confirmed along with any coding requirements.
3.Confirm and pay
You receive an invoice with the part number, coding notes and warranty terms.
4.Delivery across the EU
The rack ships protected against transit damage, with tracking.
Electric steering rack FAQ
- Does an EPS rack need programming after installation?
- In most cases yes. The unit has to be coded to the vehicle and the steering angle sensor calibrated, which requires a diagnostic tool that supports your brand.
- Why does my electric steering cut out when the car is warm?
- That pattern usually points at the assist motor or a failing torque sensor. Read the stored codes in the steering module before ordering parts.
- Can the ECU be repaired instead of replacing the whole rack?
- Sometimes. Send the fault codes and we will tell you whether a control unit repair is realistic for your model.
- Is a wheel alignment needed afterwards?
- Yes, and the steering angle sensor must also be calibrated after the alignment.