Power steering pumps: OE and quality aftermarket units

A whining pump, heavy steering at idle or fluid loss usually ends with the pump. We supply pressure-tested hydraulic power steering pumps — original and quality aftermarket — matched to your vehicle by VIN and shipped across Europe.

Why our pumps hold up

Pressure tested

Every pump is tested for output pressure and flow, so you know it can support the rack it will drive.

Correct pulley and reservoir setup

Pulley diameter, belt profile and reservoir type differ between engine variants. We confirm all three before shipping.

Seal kits included where relevant

Pumps ship with the O-rings and seals needed for a clean installation instead of forcing a second parts order.

OE or aftermarket, your call

We quote both when available so you can balance budget and warranty expectations.

Getting the right pump first time

Power steering pumps vary by engine, not just by model. A 1.6 petrol and a 2.0 diesel of the same car will usually take different pumps with different pressure ratings and mounting brackets.

  • VIN and engine code
  • Old pump part number or clear photos from several angles
  • Reservoir type: mounted on the pump or remote
  • Symptoms observed — whine, heavy steering, leak or pressure loss

Ordering in four steps

  1. 1.Describe the fault

    Send the VIN with a short description: noise, heaviness, leak or a failed pressure test.

  2. 2.We identify the pump

    You get the correct pump variant, price and lead time, plus a note if the rack should be inspected too.

  3. 3.Confirm and pay

    An invoice with the part number and warranty terms is issued before dispatch.

  4. 4.Delivery across the EU

    Tracked shipping to your workshop or home address.

Power steering pump FAQ

My steering whines — is the pump always to blame?
Not always. Low fluid, air in the system or a leaking rack that drains the reservoir cause the same noise. Check the fluid level and look for leaks before replacing the pump.
Should the fluid be flushed when fitting a new pump?
Yes. Debris from a failed pump circulates through the system and will damage the new one, so a full flush is part of a correct installation.
Can a failing rack destroy a new pump?
It can. A rack with internal bypass or a leak keeps the pump running dry or overloaded, so both parts should be assessed together.
Do you supply electro-hydraulic (EHPS) pumps?
Yes, for many models. Send the VIN and we will confirm availability for your specific unit.